Eiki EIP-XSP2500 Owner's Manual download pdf (Page 18)

Power off the Projector

1. Press ON/STANDY-BY button on the projector or

POWER button on the remote control and the

confirmation message for shut-down displays on the

screen.

2. Press ON/STANDY-BY button on the projector or

POWER button on the remote control again to turn

off the projector. The LED indicator flashes red and

green, and the projection lamp shuts down. After the

projector is turned off, the cooling fans operate about

120 seconds. You cannot turn on the projector during

this cooling down period.

3. When the projector has cooled down enough, the

LED indicator lights orange and then you can turn on

the projector.

CAUTION

To protect the lamp, the projector will not respond to any commands during the cooling process.

Do not unplug the power cord before the projector shutdown sequence is completed or during

the 120-second cooling down process.

If the projector is not properly shut down, to protect the lamp, when you attempt to re-start the

projector, the fans will run for a few minutes to cool down. Press POWER again to start the

projector after the fans stop and the POWER indicator light steady orange.

Disconnect the power cord from the wall socket if the

projector will not be used in an extended period of time.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 42 43

No comments

Eiki EIP-XSP2500 Owner's Manual Page 18