Eiki EIP-XSP2500 Owner's Manual download pdf (Page 34)

WARNING

Dispose of a lamp in accordance with the local recycling laws.

Do not put it to your trash.

Recycling Lamp’s laws of the USA, go to www.lamprecycle.org

Recycling Product’s laws of USA, go to www.eiae.org

Recycling Product’s laws of Canada, go to www.epsc.ca

For more information about recycling laws, please contact local government agency or dealer.

To reduce the risk of electrical shock, always turn the projector off and disconnect the power cord before

changing the lamp.

To reduce the risk of severe burns, allow the projector to cool for at least 45 minutes before replacing the

lamp.

To reduce the risk of injuries to fingers and damage to internal components, use caution when removing

lamp glass that has shattered into sharp pieces. Before replacing the lamp, clean the lamp compartment

and dispose of cleaning materials. Be careful of sharp edges in the lamp compartment. Wash hands after

lamp replacement.

Turn the power off and disconnect the projector from the wall socket before replace the lamp. Follow with

below instruction.

CAUTION Do not turn the power on with the lamp cover removed.

Resetting the Lamp Timer

1. Press MENU button of remote control or unit to turn on the OSD.

2. Press

button to System Setup-Advance category

3. Press

button to Reset Lamp Timer

4. Press Enter Key

to show the “confirm again” page and select OK to reset the lamp timer.

CAUTION Do not reset if the lamp is not new or replaced as this could cause damage.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 42 43

No comments

Eiki EIP-XSP2500 Owner's Manual Page 34