Eiki LC-X800 Owner's Manual download pdf (Page 20)

Terminals of Projector

The projector has two replaceable Interface board slots. The projector's functions can be extended by installing

the optional interface boards into the terminal slots. 2 vacant slots (Input 3 and 4) are provided in your

purchasing the projector. For the Optional Interface Boards, contact sales dealer where you purchased the

projector.

Pull out the interface board.

Remove 2 Screws from an interface board.

Tighten screws to secure the interface board.

Replace the interface board. Insert a new interface

board along Guide to ﬁt Socket to inside Plug.

INPUT/OUTPUT

TERMINALS

Guide

Socket

Plug

Figure shows Dual-SDI terminal.

DVI / D-sub 15 Terminal 5-BNC / VideoTerminal

2 TERMINAL SLOTS (Factory set)

NOTES ON ORDERING OR USING

OPTIONAL INTERFACE BOARD

When ordering or using Optional Interface Board, contact

your sales dealer. When contacting the sales dealer, tell the

Option Control Number (Op.cont.No.) in the menu that is

located on the bottom of the information menu.

(See page 28)

✔Note:

• In the replacement of interface board, turn off the

projector, press the Main On/Off Switch to Off and

unplug the AC power cord from the AC outlet.

Replacement of Terminal

Installation

Screws

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 84 85

No comments

Eiki LC-X800 Owner's Manual Page 20