Eiki LC-X800 Owner's Manual download pdf (Page 18)

Installation

Lens Installation

Before setting up the projector, install Projection Lens on the projector.

Before installation, check where the projector is used and prepare a suitable lens. For the specifications of

Projection Lens, contact sales dealer where you purchased the projector.

- Do not use the optional lens below for this projector. Otherwise damages may result.

LENS MODEL NO. : AH-21031, AH-21032

- Lens installation and replacement should be made by the qualified service personnel.

- When setting the projector after lens installation, be sure to replace a Lens Cap to protect a

surface.

- When carrying or holding up the projector, be careful not to put your hands on lens part. It may

damage lens, cabinet, or mechanical parts.

Installing the Strap for safety

Secure the lens mount cover and the projector with the

strap (supplied) to prevent the lens mount cover from

falling down.

Fig. 1

Screw A

Fig. 3

Label

Dot on the cabinet

Dot on the lens

mount cover

Strap

Remove the screw A. (See Fig. 1)

Turn the lens mount cover counter-clockwise and

take it off by pulling forward. (See Fig. 1)

Fit the raised dot of the lens mount cover to the

leftmost edge of the Label on the projector, and

then turn the lens mount cover clockwise and

adjust the position of the raised dot to the one of

the projector until it makes a clicking sound. (See

Fig. 3)

Put the strap through the hole of the lens mount

cover and fasten it ﬁrmly. (See Fig. 2)

Fig. 2

Strap

Lens Mount Cover

Screw A

Install the other end of the strap to the front of

the projector with screw A. (See Fig. 3)

✔Note:

• The accessory screw (supplied) is not used for installation.

Lens Mount Cover

Hole

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 84 85

Comments to this Manuals

No comments

Eiki LC-X800 Owner's Manual Page 18

Comments to this Manuals

Related products and manuals for Projectors Eiki LC-X800