Eiki LC-X800 Owner's Manual download pdf (Page 12)

Terminals and Connectors

rR/C JACK

When using the wired remote control, connect the

wired remote control to this jack with a remote

control cable (supplied).

eUSB CONNECTOR (Series B)

USB connector is to used to service the projector.

iS-VIDEO INPUT JACK

Connect the S-VIDEO output signal from video

equipment to this jack (p.21).

q

SERIAL PORT IN TERMINAL

If you control the projector by computer, you must

connect a cable (not supplied) from your computer

to this terminal.

w

SERIAL PORT OUT TERMINAL

This terminal outputs signal from SERIAL PORT IN.

More than two projectors can be controlled with

one computer by connecting SERIAL PORT IN of

another projector to this terminal.

u5 BNC INPUT JACKS

Connect the component or composite video

output signal from video equipment to VIDEO/Y,

Pb/Cb, and Pr/Cr jacks or connect the computer

output signal (5 BNC Type [Green, Blue, Red,

Horiz. Sync, and Vert. Sync.]) to G, B, R, H/V, and V

jacks (pp.20–21).

[ RESET button

A built-in micro processor which controls this unit may

occasionally malfunction and need to be reset. This can be done

by pressing the RESET button with a pen, which will shut down

and restart the unit. Do not use the RESET function excessively.

q w

✽

t y

t

DVI INPUT TERMINAL

Connect computer output (Digital/DVI-D type) to

this terminal (p.20).

HD (HDCP Compatible) signal can be also

connected (p.21).

D-sub 15-PIN INPUT TERMINAL

Connect computer output (Analog D-sub 15-pin

type) to this terminal (pp.20–21).

Part Names and Functions

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 84 85

Comments to this Manuals

No comments

Eiki LC-X800 Owner's Manual Page 12

Comments to this Manuals

Related products and manuals for Projectors Eiki LC-X800