Eiki LC-W3 User Manual download pdf (Page 46)

APPENDIX

Turn off a projector and disconnect AC plug. Allow a projector to

cool for at least 45 minutes.

Loosen 2 screws with a screwdriver and pull out Lamp Assembly

by grasping Handle.

Replace Lamp Assembly with a new one and tighten 2 screws

back. Make sure that Lamp Assembly is set properly. Replace

Lamp Cover and tighten 2 screws.

Loosen 2 screws with a screwdriver and open Lamp Cover.

Connect AC Power Cord to a projector and turn it on.

Follow these steps to replace lamp assembly.

Reset Lamp Replace Counter (refer to next page “LAMP

REPLACE COUNTER” section).

LAMP

ASSEMBLY

HANDLE

LAMP COVER

NOTE : Do not reset Lamp Replace Counter when Projection

Lamp is not replaced.

LAMP REPLACEMENT

LAMP REPLACE

When the life of the Projection Lamp of this projector draws to an end,

the LAMP REPLACE indicator lights yellow. If this indicator lights

yellow, replace the projection lamp with a new one promptly.

ORDER REPLACEMENT LAMP

Replacement Lamp can be ordered through your dealer. When ordering a Projection Lamp, give the

following information to the dealer.

● Model No. of your projector : LC-W3

● Replacement Lamp Type No. : POA-LMP98

(Service Parts No. 610 325 2957)

For continued safety, replace with a lamp assembly of

the same type.

Do not drop a lamp assembly or touch a glass bulb! The

glass can shatter and may cause injury.

Allow a projector to cool, for at least 45 minutes before

you open Lamp Cover. The inside of a projector can

become very hot.

TOP CONTROL

CAUTION

This indicator lights yellow

when the life of the projection

lamp draws to an end.

Replace the Projection Lamp

with a new one promptly.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 59 60

Comments to this Manuals

No comments

Eiki LC-W3 User Manual Page 46

Comments to this Manuals

Related products and manuals for Projectors Eiki LC-W3