Eiki LC-SM4 User Manual download pdf (Page 37)

APPENDIX

LAMP REPLACEMENT

LAMP REPLACE

When the life of Projection Lamp of this projector draws to an end,

LAMP REPLACE indicator lights yellow. If this indicator lights yellow,

replace the projection lamp with a new one promptly.

ORDER REPLACEMENT LAMP

Replacement Lamp can be ordered through your dealer. When ordering a Projection Lamp, give the

following information to the dealer.

● Model No. of your projector : LC-SM4

● Replacement Lamp Type No. : POA-LMP37

(Service Parts No. 610 295 5712)

For continued safety, replace with a lamp assembly of

the same type.

Do not drop a lamp assembly or touch a glass bulb! The

glass can shatter and may cause injury.

Allow a projector to cool, for at least 45 minutes before

you open Lamp Cover. The inside of a projector can

become very hot.

WARNING

TEMP .

LAMP

REPLACE

TOP CONTROL

CAUTION

Turn off the projector and disconnect AC plug. Allow the

projector to cool at least for 45 minutes.

Remove 2 screws with a screwdriver and pull out Lamp

Assembly by grasping Handle.

Replace Lamp Assembly with a new one and tighten 2 screws

back into position. Make sure that Lamp Assembly is set

properly. Replace Lamp Cover and tighten the screw.

To remove Lamp Cover, remove the screw with a screwdriver .

Connect the AC Power Cord to the projector and turn on the

projector.

Follow these steps to replace the lamp assembly.

Reset the Lamp Replace Counter.

Refer to “LAMP REPLACE COUNTER” on the next page .

LAMP

ASSEMBLY

HANDLE

LAMP COVER

NOTE : Do not reset Lamp Replace Counter when Projection

Lamp is not replaced.

This indicator lights yellow

when the life of the projection

lamp draws to an end.

Replace the Projection Lamp

with a new one promptly.

SCREW

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 43 44

Comments to this Manuals

No comments

Eiki LC-SM4 User Manual Page 37

Comments to this Manuals

Related products and manuals for Projectors Eiki LC-SM4