Eiki LC-SM4 User Manual download pdf (Page 36)

SETTING

This function turns Projection Lamp off when this projector detects

signal interruption and is not used for a certain period in order to

reduce power consumption and maintain the Lamp-life. (This

projector is shipped with this function ON.)

Power Management function operates to turn Projection Lamp off

when the input signal is interrupted and any button is not pressed

over 5 minutes. This function operates as follows;

1. When any input signal is interrupted, “No signal” and the

counting down display appears (for 5 minutes).

2. After counting down for 5 minutes, Projection Lamp and

READY Indicator are turned off. (Cooling Fans keep running.)

3. READY Indicator starts to flash after cooling down Projection

Lamp about for 90 seconds (Power Management mode).

In this Power Management mode, Projection Lamp is

automatically turned on when the input signal is connected or

projector is operated with any button on Top Control or on

Remote Control Unit again.

Power management

This function is used to reset Lamp Replace Counter. When

replacing Projection Lamp, reset Lamp Replace Counter by using

this function. Refer to page 38 for operation.

Lamp counter reset

Remote control

This projector has two different remote control codes; the factory-set

normal code (Code 1) and the secondary code (Code 2). This

switching function prevents remote control operation mixture (jam)

when operating several projectors or video equipment together.

When operating projector in “Code 2,” both projector and Remote

Control Unit must be switched to “Code 2.”

To change the code of Projector;

Set Remote control in the SETTING MENU to “Code 2.”

To change the code of the Remote Control Unit;

Press both MENU and IMAGE buttons on Remote Control Unit

together for over 10 seconds.

After changing the code, make sure Remote Control Unit operates

properly.

To return to the normal code (Code 1), operate both projector and

Remote Control Unit in the ways above again.

NOTE : When battery of Remote Control Unit is replaced, the remote

control code automatically returns to the normal code (Code

1).

Time left until Lamp off.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 42 43 44

Comments to this Manuals

No comments

Eiki LC-SM4 User Manual Page 36

Comments to this Manuals

Related products and manuals for Projectors Eiki LC-SM4