Eiki LC-SD12 Owner's Manual download pdf (Page 14)

This projector uses nominal input voltages of 100-120 V or 200-240

V AC. This projector automatically selects the correct input

voltage. It is designed to work with single-phase power systems

having a grounded neutral conductor. To reduce risk of electrical

shock, do not plug into any other type of power system.

Consult your authorized dealer or service station if you are not sure

of the type of power supply being in use.

Connect a projector with a peripheral equipment before turning a

projector on. (Refer to page 15 –16 for connection.)

CAUTION

For safety, unplug the AC Power Cord when an appliance is not used.

When this projector is connected to the outlet with the AC Power Cord,

an appliance is in the Stand-by Mode and consumes a little electric

power.

Connect the AC Power Cord (supplied) to the

projector. The AC outlet must be near this

equipment and must be easily accessible.

Note:

The AC Power Cord must meet requirement of the country where you use the projector.

Confirm an AC plug type with the chart below and proper AC Power Cord must be used.

If supplied AC Power Cord does not match your AC outlet, contact your sales dealer.

To POWER CORD

CONNECTOR on your

projector.

Projector side

AC Outlet side

Ground

To the AC Outlet.

(120 V AC)

For Continental Europe

For the U.S.A. and Canada

To the AC Outlet.

(200 - 240 V AC)

Connecting the AC Power Cord

Installation

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 51 52

No comments

Eiki LC-SD12 Owner's Manual Page 14