Eiki LC-XB42 User Manual download pdf (Page 60)

60

Appendix

No image – Check the connection between your computer or video equipment

and the projector. (See pages 16-18)

– See if the input signal is correctly output from your computer. Some

laptop computers may need to change the setting for monitor output

when connecting to a projector. See your computer’s instruction

manual for the setting.

– It takes about 30 seconds to display an image after turning on the

projector. (See page 19)

– Check the Input signal, color system, video system or computer

system mode.

– Make sure the temperature is not out of the specified Operating

Temperature (41˚F–95˚F [5˚C–35˚C]).

– When "No Show" is operating, the image cannot be displayed. Press

the NO SHOW button or any other button on the remote control.

No sound – Check the audio cable connection from audio input source.

– Adjust the audio source.

– Press the Volume + button. (See page 24)

– Press the Mute button. (See page 24)

– When the AUDIO OUT is plugged-in, the projector's built-in speaker

is not available

– Is the image projected? You will hear the sound only when the image

is projected.

The color is strange. – Check the Input signal, color system,video system or computer

system mode.

– Make sure the "Blackboard" is not selected on Image select

menu.(see pages 32,39)

Some displays are not seen – Check the Display function. (See page 44)

during the operation.

Auto PC adjustment function – Check the Input signal. Auto PC function can not work when

does not work. 480p,575p.720p,480i,575i,1035i or 1080i is selected.

(see page 29)

The setting does not remain – Make sure you selected "Store" after adjusting setting. Some settings

after turning off power. can not be stored if not registered with "Store".(see page 41)

Power management does not – Power management function can not work while "Freeze" or "No

work. Show" function is running.(see pages 25 , 26)

Capture function does not work. – Check the connection and the input signal to see if there is signal.

Auto setup does not work properly. – Make sure "Off" is not selected at the Auto setup function.(see page

43)

– Make sure "On" is not selected at the Ceiling function.(see page 47)

Auto keystone function does not – Make sure the Auto keystone function is not set to "Manual". Press

work even when the projector is the AUTO SET UP button on the top control.(see pages 23,43)

tipped.

Eiki LC-XB42 User Manual Page 60

Comments to this Manuals

Eiki LC-XB42 User Manual Page 60

Comments to this Manuals

Related products and manuals for Projectors Eiki LC-XB42