Eiki LC-WAU200 Owner's Manual download pdf (Page 20)

Installation

Connecting the AC power cord

This projector uses nominal input voltages of

100–240V AC and it automatically applies to

different input voltages. It is designed to work

with a single-phase power system having a

grounded neutral conductor. To reduce the risk

of electrical shock, do not plug into any other

type of power system. If you are not sure of

the type of power being supplied, consult your

authorized dealer or service center. Connect

the projector with all peripheral equipment

before turning it on.

The AC outlet should be near this equipment and must be easily accessible.

Note:



Note:

For safety, unplug the AC power cord when the projector is not in use. When the projector is connected to an

outlet with AC power cord, it is in stand-by mode and consumes a little electric power.

√ Note:

● Using incorrect power cord may inuence the product performance, or even cause hazards like an

electric shock or re. To ensure the product performance and security, please apply the cable of the

same model with the original one.

● Common connecting cables include the AC power cord, various VGA cables, video cable,and serial

control cable.

Note on the power cord

AC power cord must meet the requirements of the country where you use the projector. Conrm the AC

plug type with the chart below and proper AC power cord must be used. If the supplied AC power cord

does not match.

Projector side

AC outlet side

For the U.S.A. and

Canada

For Continental

Europe

For the U.K.

To power cord

connector on your

projector.

Ground

To the AC outlet.

(110 V AC)

To the AC outlet.

(200 - 240 V AC)

To the AC outlet.

(200 - 240 V AC)

Ground

Connect the AC power cord

to the projector.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 71 72

Comments to this Manuals

No comments

Eiki LC-WAU200 Owner's Manual Page 20

Comments to this Manuals

Related products and manuals for Projectors Eiki LC-WAU200